Search
All Categories > ASR® - Automatic Scrap Recycling > IN-Series Trim Removal Inducers > Item # IN405  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # IN405, IN-Series Trim Removal Inducers





Process Control's IN Series Inducers are designed to pick up and convey edge and/or bleed trims generated in the production of plastic film or other thin-gauge products such as foam, tape, paper or foil. These continuous trims are picked up by suction, conveyed into the inducer's venturi section and blown to a destination such as a Process Control film grinder or a waste container.

Process Control inducer manifolds are designed to insure that the air velocity at the pickup point is maintained so that trims do not wrap around the cutters.

The IN Series inducers feature an adjustable venturi to allow you to tune the inducer for peak performance with your installation.

IN Series inducers have a higher induced air to primary air ratio than conventional trim removal systems, providing excellent pickup and conveying performance.

IN Series inducers are designed to adapt easily to the installation requirements of your extrusion lines. The unit is shipped with its fan in a top- horizontal arrangement, but can be easily rotated in 90° increments to provide the required fan/venturi orientation. The fan may also be mounted remotely from the venturi using additional tubing.

Standard Features
  • 5 - 20 HP AC, TEFC motors
  • Power Requirements: 460/3PH/60Hz
  • Electricals: Starter and controls are normally included in a PCC Grinder control panel when purchased as part of a complete asr® (Automatic Scrap Recycling system), or can be supplied in a separate standalone panel.
  • Silencer on the fan inlet
  • Mild steel construction
  • High gloss epoxy paint in PCC standard color
Options
  • Interconnecting tubing and hardware
  • Venturi inlet bell-mouth
  • Edge and/or bleed trim pickup manifolds
  • Silencers on the venturi inlet and outlet
  • AEN air eliminator to separate conveying air from trims
  • Special electricals
  • Special paint
The IN Series: trim removal component for use with asr® systems to recycle edge trim, roll scrap and loose scrap individually or simultaneously.




Specifications  · Dimensions  · Electrical Power Requirements

Specifications

Motor Power
5 hp
3.7 kW

Line Speed
Up to 600 ft/min

Inlet Size
4.0 in
102 mm

Outlet Size
6.63 in
168 mm

TEFC Motor Power (AC)
5 to 20 hp

Material of Construction

Mild Steel

Paint Type
High Gloss Epoxy Paint at PCC Standard Color


Dimensions

Dimension A
44.0 in
1115 mm

Dimension B
25.0 in
635 mm

Dimension C
16.0 in
400 mm

Dimension D
35.0 in
885 mm

Dimension E
16.0 in
400 mm

Dimension F
26.0 in
660 mm

Dimension G
7.0 in
178 mm

Dimension H
14.0 in
356 mm


Electrical Power Requirements

Voltage
460 V

Phase
Three

Frequency
60 Hz


 MORE IMAGES 

·  IN-Series Trim Removal Inducers - Trim Pickup Manifold

·  GF and GFA Series Film Scrap Grinder & Accessories - Automatic Scrap Recycling System


 DOWNLOADS 

IN-Series Trim Removal Inducers - Data Sheet
(PDF, 745KB)



 AEN Air Eliminator 


AEN-Series Air Eliminator
AEN-Series Air Eliminator

Privacy  |  Sitemap  |  Site created by ThomasNet Web Solutions and powered by Navigator Platform
Process Control Corporation | Auxilary Equipment For The Plastics Processing IndustryProcess Control Corporation | Auxilary Equipment For The Plastics Processing Industry Process Control Corporation | Auxilary Equipment For The Plastics Processing Industry